PPG INDUSTRIES INC COATINGS & RESINS GROUP -- DP402LF EPOXY PRIMER CATALYST -- 8010-00F050512
=====================  Product Identification  =====================

Product ID:DP402LF EPOXY PRIMER CATALYST
MSDS Date:04/29/1994
FSC:8010
NIIN:00F050512
=== Responsible Party ===
Company Name:PPG INDUSTRIES INC COATINGS & RESINS GROUP
Address:4325 ROSANNA DR
Box:9
City:ALLISON PARK
State:PA
ZIP:15101-5000
Country:US
Info Phone Num:412-492-5555
Emergency Phone Num:304-843-1300
CAGE:DO542
=== Contractor Identification ===
Company Name:PPG INDUSTRIES INC. COATINGS & RESINS GP
Address:4325 ROSEANNA DR PO BOX 9
Box:9
City:ALLISON PARK
State:PA
ZIP:15101
Phone:412-492-5555
CAGE:DO542

=============  Composition/Information on Ingredients  =============

Ingred Name:ALIPHATIC AMINE ADDUCT
Fraction by Wt: 5-10%

Ingred Name:DIETHYLENETRIAMINE, ETHYLENEDIAMINE, N-(2-AMINOETHYL);     
     BIS(2-AMINOETHYL)AMINE *96-2*
CAS:111-40-0
RTECS #:IE1225000
Fraction by Wt: 1-2%
Other REC Limits:4 MG/CUM
ACGIH TLV:1 PPM (SKIN)

Ingred Name:PROPYLENE GLYCOL METHYL ETHER (1-METHOXY-2-PROPANOL)       
    PROPYLENE GLYCOL MONO METHYL ETHER *96-2*
CAS:107-98-2
RTECS #:UB7700000
Fraction by Wt: 30-35%
Other REC Limits:100 PPM
ACGIH TLV:100 PPM

Ingred Name:METHYL ETHYL KETONE, 2-BUTANONE   *96-2*
CAS:78-93-3
RTECS #:EL6475000
Fraction by Wt: 10-15%
Other REC Limits:590 MG/CUM
OSHA PEL:200 PPM
ACGIH TLV:590 MG/CUM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:2-HEPTANONE, METHYL N-AMYL KETONE
CAS:110-43-0
RTECS #:MJ5075000
Fraction by Wt: 5-10%
Other REC Limits:50 PPM
OSHA PEL:465 MG/CUM
ACGIH TLV:233 MG/CUM

Ingred Name:ISOPROPANOL (ISOPROPYL ALCOHOL), 2-PROPANOL, DIMETHYL
    CARBINOL	(IARC CANCER REVIEW GROUP 3)   *96-2*
CAS:67-63-0
RTECS #:NT8050000
Fraction by Wt: 2-5%
Other REC Limits:400 PPM
OSHA PEL:400 PPM
ACGIH TLV:400 PPM

Ingred Name:BUTANOL, N-BUTYL ALCOHOL, PROPYL CARBINOL, BUTYL ALCOHOL
CAS:71-36-3
RTECS #:EO1400000
Fraction by Wt: 5-10%
Other REC Limits:300 MG/CUM
OSHA PEL:100 PPM
ACGIH TLV:C 152 MG/CUM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:TOLUENE (IARC CARC- GROUP 3)     *96-2*
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 2-5%
Other REC Limits:375 MG/CUM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ISOPARAFFINIC HYDROCARBONS (NAPHTHA PETROLEUM),
    HYDROTREATED HEAVY, NON AROMATIC HEAVY NAPHTHA) ISOPAR G
CAS:64742-48-9
Fraction by Wt: 1-2%

Ingred Name:OXO-HEXYL ACETATE	   *96-2*
CAS:88230-35-7
Fraction by Wt: 2-5%

Ingred Name:FILM FORMERS, RESINS, AND ADDITIVES
Fraction by Wt: 20-25%

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:HARMFUL IF SWALLOWED/INHALED. MAY BE
    ABSORBED THROUGH THE SKIN. EYES: MAY CAUSE IRREVERSIBLE DAMAGE.
    SKIN: CORROSIVE, BURNS & ALLERGIC REACTIONS. INHALATION: HIGH VAPOR
    CONCENTRATIONS MAY CAUSE IRRITA TION OF THE RESPIRATORY SYSTEM &
    PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, EYE WATERING, HEADACHES, NAUSEA,
    DIZZINESS, LOSS OF COORDINATION, REDNESS, ITCHING, BURNING, VISUAL
    DISTURBANCES, DRYNESS, CRACKING, SWELLING.

=======================  First Aid Measures  =======================

First Aid:INGESTION: GIVE 1-2 GLASSES OF WATER. DON'T INDUCE VOMITING.
    SKIN: FLUSH W/WATER, FOLLOWED BY WATERLESS HAND CLEANER & SOAP.
    INHALATION: REMOVE TO FRESH AIR. GIVE CPR IF NEEDED. EYES: FLUSH
    W/WATER FO R 30 MINS. OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:36F
Lower Limits:1.7
Extinguishing Media:CO2, DRY CHEMICAL/UNIVERSAL AQUEOUS FILM FORMING
    FOAM.
Fire Fighting Procedures:WATER SPRAY MAY BE INEFFECTIVE. WATER SPRAY
    MAY BE USED TO COOL CLOSED CONTAINERS. IF WATER IS USED, FOG
    NOZZLES ARE PREFERABLE. WEAR SCBA.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
    FROM HEAT, ELECTRICAL EQUIPMENT & OTHER IGNITION SOURCES. DON'T
    APPLY TO HOT SURFACES. (SEE SUPP)

==================  Accidental Release Measures  ==================

Spill Release Procedures:USE MAXIMUM VENTILATION. ONLY PERSONNEL
    EQUIPPED W/PROPER RESPIRATORY & SKIN/EYE PROTECTION, PERMITTED.
    REMOVE IGNITION SOURCES. TAKE UP W/SAWDUST, VERMICULITE/OTHER
    ABSORBENT MATERIAL & PLACE INTO CO NTAINERS FOR DISPOSAL.

======================	Handling and Storage  ======================

Handling and Storage Precautions:GROUND CONTAINER WHEN POURING. AVOID
    FREE FALL OF LIQUIDS IN EXCESS OF A FEW INCHES. DON'T STORE >120F.
Other Precautions:INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING &
    INHALING THE CONTENTS CAN BE HARMFUL/FATAL.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH/MSHA APPROVED AIR PURIFYING/AIR
    SUPPLIED RESPIRATORS.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST VENTILATION.
Protective Gloves:BUTYL, NEOPRENE/NITRILE RUBBER
Eye Protection:CHEMICAL SPLASH GOGGLES/FULL FACE SHIELD
Other Protective Equipment:IMPERMEABLE CLOTHING
Supplemental Safety and Health
UNUSUAL FIRE CONT'D: CLOSED CONTAINERS MAY EXPLODE WHEN EXPOSED TO
    EXTREME HEAT. TOXIC GASES MAY FORM WHEN PRODUCT IS CONTACTED BY
    FLAME/HOT SURFACES.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:132-8-401F
Vapor Pres:24.9
Vapor Density:>1
Spec Gravity:0.93
Evaporation Rate & Reference:(BU OAC =100): 218
Solubility in Water:42.8
Appearance and Odor:VISCOUS LIQUID W/CHARACTERISTIC ODOR OF THE
    SOLVENTS LISTED.
Percent Volatiles by Volume:72.48

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG ALKALIES, STRONG MINERAL ACIDS/STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT, SPARKS, OPEN FLAMES, ELECTRICAL
    EQUIPMENT & OTHER IGNITION SOURCES. TEMP >120F.
Hazardous Decomposition Products:HEATED, WELDING, BRAZING/FLAME
    CUTTING: CO, OXIDES OF NITROGEN.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
    REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED/DISPOSED OF
    THROUGH AN APPROVED WASTE MANAGEMENT FACILITY.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.