CUSTOM BUILDING PRODUCTS -- SILICONE SEALER, 3014  -- 8030-00N065777
<pre>=====================  Product Identification  =====================

Product ID:SILICONE SEALER, 3014
MSDS Date:10/05/1993
FSC:8030
NIIN:00N065777
=== Responsible Party ===
Company Name:CUSTOM BUILDING PRODUCTS
Address:6511 SALT LAKE AVE
City:BELL
State:CA
ZIP:90201
Country:US
Info Phone Num:213-582-0846
Emergency Phone Num:213-582-0846
Preparer's Name:S TAYLOR
CAGE:CUSTO
=== Contractor Identification ===
Company Name:CUSTOM BUILDING PRODUCTS
Address:6511 SALT LAKE AVE.
City:BELL
State:CA
ZIP:90201
Country:US
Phone:213-582-0846
CAGE:CUSTO

=============  Composition/Information on Ingredients  =============

Ingred Name:STODDARD SOLVENT;(ALIPHATIC HYDROCARBON). VP: 2.0 @ 68F.
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: 95%
OSHA PEL:500 PPM
ACGIH TLV:100 PPM

Ingred Name:VOLATILE ORGANIC CONTENT: 750 GRAMS/LITER.
RTECS #:9999999VO

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INHAL: EXCESS INHAL OF VAPS CAN CAUSE
    NASAL & RESP IRRIT, DIZZ, FATIGUE, NAUS, HEADACHE, POSS UNCON &
    EVEN ASPHYXIATION. SKIN: PRLNGD/RPTD CONT CAN CAUSE MOD IRRIT &
    DERM. CANNOT BE ABSORBED THRU SKIN . EYES: CAN CAUSE SEV IRRIT,
    TEARING & BLURRED VISION. INGEST: CAN CAUSE GI IRRIT, NAUS, VOMIT &
    DIARR.(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: ASPIR OF MATL INTO LUNGS CAN CAUSE
    CHEM PNEUM WHICH CAN BE FATAL.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN DISORDERS AND
    RESPIRATORY DISEASE.

=======================  First Aid Measures  =======================

First Aid:EYE: WASH EYES IMMED W/LGE AMOUNTS OF WATER FOR AT LEAST 15
    MINUTES. GET MED ATTN. SKIN: WASH USING SOAP & WATER. REMOVE SOAKED
    CLOTHING & WASH SKIN WITH SOAP & WATER. IF IRRIT PERSISTS AFTER
    WASHING,  GET MED ATTN. INHAL: REMOVE TO FRESH AIR. SUPPORT
    BREATHING(ARTF RESP). INGEST: CALL MD IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point Method:CC
Flash Point:100F,38C
Lower Limits:0.7%
Upper Limits:7.0%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT.
Unusual Fire/Explosion Hazard:VAP ACCUM COULD FLASH/EXPLODE IF IGNITED.
    VAP IS HVR/AIR & MAY TRAVEL ALONG GROUND/BE MOVED BY VENT & IGNITED
    BY HEAT, PILOT LIGHTS, OTHER FLAMES & (SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL POSSIBLE IGNITION SOURCES.
    VENTILATE AREA OF SPILL. ABSORB AND DISPOSE OF IN ACCORDANCE WITH
    FEDERAL, STATE & LOCAL REGULATIONS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN COOL AND WELL VENTILATED
    AREA.
Other Precautions:DO NOT WELD, HEAT OR DRILL ON OR NEAR CONTAINERS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV IS EXCEEDED, USE NIOSH/MSHA APPROVED
    SCBA.
Ventilation:NEED EQUIVALENT TO OUTDOORS VENTILATION. USE EXPLOSION
    PROOF EQUIPMENT.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:EMERGENCY EYEWASH & DELUGE SHOWER MEETING
    ANSI DESIGN CRITERIA. PROTECTIVE CLTHG TO PVNT SKIN CONTACT.
Work Hygienic Practices:GOOD HOUSEKEEPING PRACTICES SHOULD BE OBSERVED.
Supplemental Safety and Health
EXPLO HAZ: IGNITION SOURCES AT LOCATIONS DISTANT FROM MATERIAL HANDLING
    POINT. EYE PROT: & FULL LENGTH FACESHIELD.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:300F,149C
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:0.8(H*20=1)
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:CLEAR LIQUID, PETROLEUM ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
AVOID STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:AVOID CNDTN THAT CAN YIELD LARGE
    CONCENTRATIONS OF VAPORS.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS SUCH AS
    CARBON DIOXIDE AND CARBON MONOXIDE & VARIOUS HYDROCARBONS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE &
    FEDERAL REGULATIONS. USE QUALIFIED DISPOSAL COMPANY TO INCINERATE
    OR OTHER-WISE DISCARD, AT AN APPROVED FACILITY. DO NOT INCINERATE
    CLOSED CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.